neon wire Description
Product Name neon wire Brand KPT Country of Origin shanghai Model 1-5MM Product Description FLEXIBLE NEON WIRE ( EL WIRE)Flexible Neon Wire, also called Electroluminescent (EL ) Wire is the new generation product in global lighting and display industry. Wrapped by colorful plastic tube on its surface, it appears similar to common phone wire, emitting light along its entire length but without any heat radiation. It consumes much lower power, just 50-70% of LED lamp, 20-40%,rope lamp and 1- 10% neon light. Funded by China government, it was developed and put into production by professional Institute of Chinese Academy of Science, thus opening a new era in lighting and display field featured with energy saving, environmental protection and health. Patent NO. ZL011333442.1PRODUCT CHARACTERISTIC1. Homogeneous light along the entire length with wide range of vivid color, great and comfortable to be seen in darkness.2. Low energy consumption, environmentally friendly, safe: wide range voltage application, suitable for both AC and DC, non-toxicant and no harm to human being. 3. Flexible, can be bent, twisted, stretched and spliced, brightness will not be affected, easy to stall, no need of any professional background.4. Comes in entire length, animated and colorful lighting effect can be achieved by controlling relating electric circuit . 5. Be fixed on decoration surface directly by using transparent adhesive tape, glue, clip, thread, nail, plastic card etc. Specifications TECH DATA Power 0.4-0.8 W/m Brightness 5-100 Cd/m2 Standard Type 1.0-5.0 mm Operation Current 6- 15mAAverage Application lifetime 5000 hrs Shape Round, quadrate, with drapeMaximum Length 100 m Weight 4-18 g/mOperation temperature under zero 40 to 60 centigrade degree Color Red, Blue, Green, Orange, WhiteApplication Requirements Inverter/driver be matched Input: DC 3V, 6V, 9V, 12V, 24V,AC 220V,110VOutput: Voltage 90 -150V Frequency 800 - 2000Hz Advantages 1. Strip the plastic layer, exposing the lighting layer and two fine copper wire (the second electrode ) then remove half of lighting layer, exposing the first copper electrode2. Separate the two copper electrodes, solder them with two electrodes of common wire respectively, wrap each of the joint with shrinkable tube, make sure the two soldered joints are not touching to avoid short circuit.3. Cover the soldered joints with shrinkable tube again, keep it insulating and humid - protective with glue. 4. EL wire joint method is same as the above. Min Order 1000M Standard Met GB/Q/CKR01-2001
_301.jpg)
